Die vorliegende Dissertation hat sich unter dem Titel >>„Woher soll ich denn vorher wissen, ob ich den Job liebe?“ – Eine qualitative Längsschnitt-Studie zur Differenzierung der Phasenstruktur vorliegender Modelle beruflicher Orientierung anhand von Jugendlichen aus drei kontrastierenden institutionellen Ausgangslagen<< dem Erkenntnisinteresse gewidmet, Modelle zur beruflichen Orientierung anhand eines ethnografischen Zugangs aus der Perspektive unterschiedlicher institutioneller Settngs weiterzuentwickeln, um der Komplexität gegenwärtiger Lebenswelten besser gerecht zu werden. Dabei wurde unter Betrachtung von Berufsorientierungsaspekten als Forschungsgegenstand sowie unter Betrachtung der Gestalt der Berufsorientierung als Forschungsfeld der Fragestellung nachgegangen, inwiefern sich das in der Debatte zentrale Sechs-Phasenmodell der Berufswahl nach Herzog et. al. (2006) im Licht ethnografischer Forschung, welche die Perspektiven Jugendlicher eines allgemeinbildenden Gymnasiums, eines beruflichen Gymnasiums sowie eines Freiwilligen Sozialen Jahres umfasst, ausdifferenzieren lässt. Dabei wurde die Grounded Theory-Methodologie als Forschungsstil zugrunde gelegt, der wiederum im Rahmen der Datenerhebung die Ethnografie, im Rahmen der Datenanalyse die Grounded Theory untergeordnet wurde. Als zentrales Untersuchungsergebnis lässt sich zum einen aufführen, dass das bestehende Berufswahlmodell deutlich modifiziert, ausdifferenziert und folglich erweitert werden konnte. Mit dieser Erweiterung ist eine Spezifikation dahingehend verbunden, dass viele Komponenten und Ebenen hinzugekommen sind, die bei dem ursprünglichen Modell nicht bedacht waren, im Gegenzug jedoch auch solche Komponenten gestrichen und als irrelevant deklariert wurden, die sich anhand der Untersuchungsdaten nicht zu bestätigen wussten. So konnte ein Neun-Phasenmodell der Berufsorientierung in Gestalt eines Ablaufdiagramms entstehen, das den Prozessverlauf beruflicher Orientierung anschaulich in Phasen eingebettet darzustellen vermag. Dabei ist es gelungen, das Modell derart auszugestalten, dass es institutionsübergreifend anwendbar und nicht lediglich auf eine bestimmte institutionelle Ausgangslage beschränkt ist. Zum anderen kann statuiert werden, dass das vorliegende neunphasige Modell vor allem Phasen der Orientierungslosigkeit und der Desorientierung, des Entscheidungsaufschubs, der Überprüfung und der Überbrückung sowie der Um- und Neuorientierung explizit zu nutzen weiß, um diejenigen Situationen zu berücksichtigen, die den beruflichen Orientierungsprozess der Untersuchungsteilnehmenden aus allen drei institutionellen Ausgangslagen maßgeblich geprägt haben.

In international business relationships, such as international railway operations, large amounts of data can be exchanged among the parties involved. For the exchange of such data, a limited risk of being cheated by another party, e.g., by being provided with fake data, as well as reasonable cost and a foreseeable benefit, is expected. As the exchanged data can be used to make critical business decisions, there is a high incentive for one party to manipulate the data in its favor. To prevent this type of manipulation, mechanisms exist to ensure the integrity and authenticity of the data. In combination with a fair exchange protocol, it can be ensured that the integrity and authenticity of this data is maintained even when it is exchanged with another party. At the same time, such a protocol ensures that the exchange of data only takes place in conjunction with the agreed compensation, such as a payment, and that the payment is only made if the integrity and authenticity of the data is ensured as previously agreed. However, in order to be able to guarantee fairness, a fair exchange protocol must involve a trusted third party. To avoid fraud by a single centralized party acting as a trusted third party, current research proposes decentralizing the trusted third party, e.g., by using a distributed ledger based fair exchange protocol. However, for assessing the fairness of such an exchange, state-of-the-art approaches neglect costs arising for the parties conducting the fair exchange. This can result in a violation of the outlined expectation of reasonable cost, especially when distributed ledgers are involved, which are typically associated with non-negligible costs. Furthermore, the performance of typical distributed ledger-based fair exchange protocols is limited, posing an obstacle to widespread adoption. To overcome the challenges, in this thesis, we introduce the foundation for a data exchange platform allowing for a fully decentralized fair data exchange with reasonable cost and performance. As a theoretical foundation, we introduce the concept of cost fairness, which considers cost for the fairness assessment by requesting that a party following the fair exchange protocol never suffers any unilateral disadvantages. We prove that cost fairness cannot be achieved using typical public distributed ledgers but requires customized distributed ledger instances, which usually lack complete decentralization. However, we show that the highest unilateral cost are caused by a grieving attack. To allow fair data exchanges to be conducted with reasonable cost and performance, we introduce FairSCE, a distributed ledger-based fair exchange protocol using distributed ledger state channels and incorporating a mechanism to protect against grieving attacks, reducing the possible unilateral cost that have to be covered to a minimum. Based on our evaluation of FairSCE, the worst-case cost for data exchange, even in the presence of malicious parties, is known, which allows an estimate of the possible benefit and, thus, the preliminary estimate of economic utility. Furthermore, to allow for an unambiguous assessment of the correct data being transferred while still allowing for sensitive parts of the data to be masked, we introduce an approach for the hashing of hierarchically structured data, which can be used to ensure integrity and authenticity of the data being transferred.

The biodegradable polymers polylactic acid (PLA) and polyhydroxybutyrate (PHB) produced from renewable raw materials were coated with hydrogenated amorphous carbon layers (a-C:H) at different deposition angles with various thicknesses as part of this thesis. Similar to conventional polymers, biopolymers often have unsuitable surface properties for industrial purposes, e.g. low hardness. For some applications, it is therefore necessary and advantageous to modify the surface properties of biopolymers while retaining the main properties of the substrate material. A suitable surface modification is the deposition of thin a-C:H layers. Their properties depend essentially on the sp² and sp³ hybridization ratio of the carbon atoms and the content of hydrogen atoms. The sp²/sp³ ratio was to be controlled in the present work by varying the coating geometry. Since coatings at 0°, directly in front of the plasma source, contain a higher percentage of sp³ and indirectly coated (180°) a higher amount of sp², it is shown in this work that it is possible to control the sp²/sp³ ratio. For this purpose, the samples are placed in front of the plasma source at angles of 0, 30, 60, 90, 120, 150 and 180° and coated for 2.5, 5.0, 7.5 and 10.0 minutes. For the angles 0°, the layer thicknesses were 25, 50, 75 and 100 nm. The a-C:H layers were all deposited using radio-frequency plasma-enhanced chemical vapor deposition and acetylene as C and H sources after being pretreated with an oxygen plasma for 10 minutes. Following the O₂ treatment and the a-C:H deposition, the surfaces are examined using macroscopic and microscopic measurement methods and the data is then analyzed. The surface morphology is recorded using scanning electron microscopy and atomic force microscopy. In addition, data on the stability of the layer and the surface roughness can be collected. Contact angle (CA) measurements are used to determine not only the wettability, but also the contact angle hysteresis by pumping the drop volume up and down. By measuring the CA with different liquids and comparing them, the surface free energy (SFE) and its polar and disperse components are determined. The changes in barrier properties are verified by water vapor transmission rate tests (WVTR). The chemical analysis of the surface is carried out on the one hand by Fourier transform infrared spectroscopy with specular reflection and on the other hand by synchrotron-supported techniques such as near-edge X-ray absorption fine structure and X-ray photoelectron spectroscopy. When analyzing the surfaces after the O₂ treatment, which was initially assumed to serve only to clean and activate the surface for the a-C:H coating, it was found that the changes were more drastic than originally assumed. For example, if PLA is treated at 0° for 10 minutes, the roughness increases fivefold. As the angle increases, it decreases again until it returns to the initial value at 180°. This can be recognized to a lesser extent with PHB at 30°. For both polymers, it can be shown that the polar fraction of the SFE increases. In the WVTR, a decrease in permeability can be observed for PLA and an increase in the initial value for PHB. The chemical surface analysis shows that the O₂ treatment has little effect on the surface bonds. Overall, it can be shown in this work that the O₂ treatment has an effect on the properties of the surface and cannot be regarded exclusively as a cleaning and activation process. With direct a-C:H coating (at 0°), a layer failure due to internal stress can be observed for both PLA and PHB. This also occurs with PHB at 30°, but to a lesser extent. Permeability of the polymers is reduced by 47% with a five-minute coating and the layer at 10.0 minutes continues to have this effect despite cracks appearing. The application of a-C:H layers shows a dominance of sp³ bonds for both polymer types with direct coating. This decreases with increasing angle and sp² bonds become dominant for indirect coatings. This result is similar for all coating thicknesses, only the angle at which the change of the dominant bond takes place is different. It is shown that it is possible to control the surface properties by an angle-dependent coating and thus to control the ratio sp²/sp³.

Nanoparticles are sensitive and robust systems; they are particularly reactive due to their large surface area and have properties that the bulk material does not have. At the same time, the production of nanoparticles is challenging, because even with the same parameters and conditions, the parameters can vary slightly from run to run. In order to avoid this, this work aims to develop a continuous synthesis in the microjet reactor for nanoceria. The aim is to obtain monodisperse nanoparticles that can be used in biosensors. This work focuses on two precipitation syntheses with the intermediate steps of cerium carbonate and cerium hydroxide, as well as a microemulsion synthesis for the production of nanoceria. The cerium oxide nanoparticles are compared using different characterisation and application methods. The synthesised nanoparticles will be characterised with respect to their size, stability, chemical composition and catalytic capabilities, by electron microscopy, X-ray diffraction, Raman spectroscopy and photoelectron spectroscopy. The biosensor systems to evaluate the nanoceria are designed to detect histamine and glucose or hydrogen peroxide, which are resulting from the oxidation of histamine and glucose. Hydrogen peroxide and glucose are detected by an electrochemical sensor and histamine by a colorimetric sensor system.

Classical music has played a central role in German music education since at least the second half of the 20th century. However, in more recent music pedagogical discourse, classical music remains a controversial topic. But what do music teachers think about classical music as a subject for music education? This topic has not yet been systematically researched in German-speaking music education. In this qualitative-empirical study, eight semi-structured interviews were conducted to address the question of how music teachers perceive classical music in music education. The data was evaluated using the Grounded Theory Methodology. The theory developed from the study indicates that music teachers have varying objectives when using classical music in music education. However, they generally consider it unfamiliar to their students. To address this situation, music teachers develop various methods and strategies. These can be categorized into three approaches for dealing with the unfamiliarity of classical music: avoidance, reduction/relativization, and utilization. The study's findings are contextualized within the framework of foreignness theory, music didactics, and transformational educational theory. This dissertation contributes to the field of music education in classical music, laying the groundwork for further theoretical, empirical, and didactic research.